Edge Cut

Elma Kujovic
Elma Kujovic
  • Updated

Use the Edge Cut tool to add extra geometry to the SubD surface.

Access and Use

  1. Open the SubD Tools Menu
  1. Grab the Edge Cut and use the trigger on your drawing hand to add extra geometry point to the surface geometry
  1. To complete the command, hover over to where you want the second point of the extra geometry and press the trigger on your drawing hand again
  1. The extra geometry has been added to the surface geometry
  1. Select the blue check mark to finish editing

Use this tool to make cut lines in products.

Was this article helpful?

/

Comments

0 comments

Please sign in to leave a comment.